911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
3. Position the support and engage in lower side member.
4. Push in the locating peg -1- of the support and check that it is sitting correctly.
5. Tighten the fastening nuts -3- and the fastening screws -2-. Tightening torque -2- 7.2 Nm (5.5ftlbs.).
6. Lay the floor covering over the support and engage.
-
Using the Porsche System Tester, read out any faults present in the POSIP menu and erase.
-
Insert sill.
-
Mount the side lining at rear.
-
Install front seat.
Tools