911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
/f6-3.6l_turbo/Page-682003.png)
2. Press the rear-wheel hub out using press-out mandrel P297a. Use the separator as a support. If there is not enough space for the wheel hub between
the press, appropriate shims will additionally be necessary.
3. Remove retainer plate (lid) (four screws).
4. Heat wheel bearing housing to approx. 100°C (max. 120°C). Press out wheel bearing with tubular piece VW415A (tool -C-).
Information:
^
Pull the inner bearing race several millimeters off the wheel hub so that the separator can be put into place.
^
For this purpose, use a two-claw puller in combination with a suitable pressure piece (e.g. VW 433).
5. Press inner wheel bearing race off the wheel hub. Use the press-out mandrel P297a in connection with the separator.
Installing
1. Before installation, clean the bore in the wheel bearing housing and remove any surface irregularities with a polishing cloth.
2. Heat wheel bearing housing to approx. 100°C (max. 120°C). Insert new wheel bearing, and then press again slightly using pressure piece 9247/3
-D- and tubular piece VW415A -C-.
