911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Removing and installing rear-wheel bearing
Notes on removal and installation
Note:
^
The wheel bearing is removed and installed with the wheel bearing housing removed.
Removal
1. Remove brake disc, parking brake shoes, brake disc cover and speed sensor.
2. Press the rear-wheel hub out using press-out mandrel P 297 a. Use the separator as a support. If there is not enough space for the wheel hub
between the press, appropriate shims will additionally be necessary.
3. Remove retainer plate (lid) (four screws).