911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Drive/Propeller Shaft: Service and Repair
Removing and Installing Cardan Shaft
Removing and installing cardan shaft
Removing cardan shaft
Note:
^
Observe maximum joint angle of 20° when removing and fitting. Furthermore, the cardan joint must not be loaded at maximum deflection (stop).
1. Remove underbody covers (rear and center).
2. Remove transmission support.
3. Detach cardan shaft at the transmission side and press it off the transmission flange with two mounting levers.
4. Pull cardan shaft out of the splines of the central shaft and remove.