911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Seals and Gaskets: Service and Repair
Removing and Installing Sealing Ring For Drive Shaft
Removing Sealing Ring For Drive Shaft
Removing sealing ring for drive shaft
1. Remove engine-transmission unit and remove the transmission.
2. Remove guide tube for release bearing.
3. Screw special tool puller 9629 securely into the sealing ring.
Note:
^
The coil spring must be pulled off the drive shaft with a wire hook if the spiral tensioning spring should jump down when removing the sealing
ring.
4. Pull out sealing ring by screwing in the hexagon-head bolt.
Installing Sealing Ring For Drive Shaft
Installing sealing ring for drive shaft
1. Push special tool assembly sleeve 9255 onto the toothing of the input shaft.
2. Fill the space between the dust and sealing lips on the sealing ring with grease (e.g. Liqui-Moly).