911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Installation position of oil-pressure sender (illustrated without intake manifold)
Installing oil-pressure sender
1. Replace sealing ring at oil-pressure sender.
2. Install oil-pressure sender.
2.1.
Fit oil-pressure sender -1- with two Torx screws (M6 x 20) and tighten screws.
The screws are accessible via the intake-air distributor on side 4-6.
-
Tightening torque: 10 Nm (7.5 ftlb.)
2.2.
Connect cable plug to sender.
Installation position of oil-pressure sender (illustrated without intake manifold)
Subsequent Work
1. Fit air-conditioning compressor.
2. Install throttle housing.
3. Install pressure pipe.