911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Insert air-conditioning line for the compressor/evaporator into the rubber mountings in the cable compartment -7-.
3. Remove the plugs used to close off the air-conditioning line, replace the O-ring on the refrigerant line and moisten it with refrigerant oil.
4. Join the two air-conditioning lines for the compressor/evaporator and secure them with the fastening screw -6-. - Tightening torque: 23 Nm (17
ftlb.)
5. Insert the two air-conditioning lines into the cable holders -7-, fold the cable holders over and secure them.
6. Engage the engine coolant line in the three holders -4-.
7. Position the crash support -5- on the body and secure with the fastening screw -3- and fastening nut -2-.
8. Install engine with air-conditioning compressor.
9. Moisten the seal for the refrigerant line using refrigerant oil. Position the refrigerant line on the fuel cooler and secure with the fastening screw -1-.
- Tightening torque: 23 Nm (17 ftlb.)