911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Clean ATF pan and place on transmission with new seal.
2. Screw in screws and tighten them crosswise. - Tightening torque: 8 Nm (6 ftlb.)
3. Engage cable and vacuum line in the retaining clips of the ATF pan.
4. Fit electric plugs.
5. Engage the coolant lines at the fastening points.
Bracket for the coolant lines
6. Install cross member.
Cross member
Topping up ATF
Caution
Oil fill level too low
^
Risk of damage to components
-
Do not start engine.
-
Do not tow the vehicle.
Information
To undo and tighten the cap nut for the charging valve, counter with a ring wrench!
1. Unscrew control screw -2-.