911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Exposing rear wire harness
1. Remove left footwell trim panel.
1.1. Remove fuse carrier cover -1- ( -arrow A- ).
1.2. Unscrew the three fastening screws -2- and take off the footwell trim panel -3- ( -arrow B- ).
2. Remove right footwell trim panel.
2.1. Partly loosen floor covering -1- at the bottom in the area of the A-pillar -arrow A-.
2.2. Unscrew both plastic nuts -2- and take off the footwell trim panel -3- ( -arrow B- ).
3. Loosen seat belt mount at left and right.
3.1. Press off cap -1- with a screwdriver and unscrew the fastening screw -2-. Remove seat belt with fitting -3- and spacer sleeve -4-.
4. Disengage floor covering at the support and lay it in the vehicle interior.
5. Remove left and right support.
5.1. Unlock locating peg -1- of the support using the commercially available removal tool Disassembly tool, universal NR.21.