911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Unclipping support bracket
7. Bend up the tabs -A- at the body opening and push the rubber sleeve outward through the body opening.
Rubber sleeve
Installing selector lever cable
Fastening selector lever cable on transmission
Information
The selector lever cable must be laid above the intermediate carrier.
1. Push cable through the body opening from below.
2. Apply a coating of lubricant (e.g. Contifix tire mounting paste) on the rubber sleeve and B+ wiring in the area of the body opening, insert the B+
wiring in the rubber sleeve and press rubber sleeve into the body opening.
Rubber sleeve in body opening
Information
During installation, make sure the selector lever on the transmission is in position P (stop to the rear).
3. Clip selector lever cable into support on transmission and press end piece of selector lever onto transmission.