911 Turbo Cabriolet AWD (997) F6-3.8L Turbo (2011)
Mill out bore hole up to dimension X using spot facer C. Milling in may only be performed using the tool contained in the Porsche special tools.
Use an electronically controlled power drill set to a speed of approx. 250 rpm (1/min) for milling in.
3. Cut thread
Cut thread into the chassis bushing using a cutting tool D up to dimension Y. Clean the thread on the chassis bushing (blow it out).
4. Position threaded bush on the screw-in tool.
Clean the thread on the bush and screw-in tool.
Oil the screw-in tool E.
Screw the threaded bush A onto the screw-in tool E by hand.
5. Screw in threaded bush
Screw threaded bush A in fully (note bush length classification) using the screw-in tool E.