911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
/f6-3.6l_turbo/Page-902004.png)
DANGER:
-
Re-tighten with correct tightening torque:
-
Carry out a test drive after performing assembly work on the roll-over bar/spring strut mount threaded parts on the body and then re-tighten the
fastening nuts -7- with the correct tightening torque.
NOTE: Initially screw in and centre all the fastening screws and fastening nuts only in the sections -A, B, D, Eand in the base cage -C-. Only then
tighten the threaded parts with the prescribed tightening torques. Adjust the adjusting element -2- last.
