911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
2. Position lifting/sliding roof drive in the teeth of the frame for the sliding roof and fasten with the Torx fastening screws -arrows-. Tightening
torque: -6 Nm (4.5 ftlb.)-
3. Engage cover on the windscreen frame at front and push rearward. Unclip locking tabs -arrows B- of the cover on the left and right. Tighten
fastening screws with a crosshead screwdriver -A-.
4. Fit cover lenses.
Emergency operation on lifting/sliding roof drive
The lifting/sliding roof drive can also be operated manually if the electric drive should fail. Check fuse D 3 before emergency operation.
-
An angle screwdriver (a/f 4 hexagon socket) is clipped in behind the cover. The drive axle can be turned with the angle screwdriver -see figure-.
The lifting/sliding roof drive must not be operated again after emergency operation.