911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
/f6-3.6l_turbo/Page-232008.png)
13. Remove camshaft bearing cap. To do so, uniformly unscrew the hexagon-head bolts of the relevant bearing covers from the inside. Remove the
bearing covers in the specified order.
14. Remove camshaft bearing covers. Lift the bearing covers up and off. The bearing covers must not be confused.
15. Remove thrust bearing cover. Unscrew the hexagon-head bolts and remove the thrust bearing cover up and off.
16. Lift camshafts up and out.
Warning: Do not confuse the flat-base tappets. The flat-base tappets have been run in their housing. Therefore, they must not be
interchanged or soiled.
17. Remove the flat-based tappets. Pull the flat-based tappets upwards out of the camshaft housing. In order to avoid confusing the individual
flat-based tappets, they should be placed on a prepared sheet of paper as shown in the diagram.
18. Remove the camshaft housing. Unscrew and remove the 18 hexagon-head bolts in the order specified. Then remove the camshaft housing.
