911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
7. Pull off electrical plug. Undo the fastening screws and remove the throttle body.
8. Pull off plug, unscrew oil temperature sensor by using a straight ring wrench, A/f 22.
Installation
1. Fasten oil temperature sensor with new sealing ring.
2. Check throttle sealing ring and replace it if necessary. Fasten throttle body. Push on electrical plug.
3. Install pressure pipe. Wet the connecting hoses between the charge air coolers and pressure pipe with water at the connecting points and fit the
hoses. The hoses must audibly engage. Then re-check whether they are positioned properly by tilting and pulling on them.
4. Install air cleaner assembly.
Location....................................................................................................................................................................... Thread Tightening torque Nm (ft lbs.)
Oil temperature sensor.................................................................................................................................................................................................. 30 (22)