911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
/f6-3.6l_turbo/Page-123001.png)
Alignment: Specifications
Adjustment Values
Adjusting values for suspension alignment
Vehicle Height
Note!
The following values relate to the empty weight, i.e. full fuel tank, vehicle with spare wheel/collapsible wheel (not GT2) and tools, but
without driver and without additional weight!
Turbo and GT2 (M002 and M003) are delivered with just one running gear tuning!
Wheel alignment values
Warning!
Warning only applies to vehicles with PSM (only 911 Turbo)!
Danger of injury and damage to property due to malfunctions in the PSM control range if the steering angle sensor is not
calibrated or is calibrated improperly!
Calibrate steering angle sensor with wheels in straight-ahead position with the Porsche System Tester 2!
The steering angle sensor actual value must be checked after a suspension alignment which resulted in no changes being made to
the wheel alignment values!
Note!
The following values relate to the empty weight, i.e. full fuel tank, vehicle with spare wheel/collapsible wheel (not GT2) and tools, but
without driver and without additional weight!
A caster adjustment is normally not necessary and is therefore not provided!
The toe-difference angle value is also influenced by the vehicle height! For this reason the measured value must be evaluated accordingly!
No action is necessary in the case of small deviations from the toe-difference angle required value, as long as the value to the right and left
is almost the same!
Front and rear axle alignment values
