911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Removal
Removal
1. Unscrew valve cap.
2. Undo fastening nut -2-. When undoing the fastening nut -2-, counter with a screwdriver in the valve foot. There is a slit in the valve foot to aid
countering. Remove disc -3- and O-ring -4-. Pull out valve -5-.
Installation
Installation
1. Insert valve -5- with the fitted foot seal -(6)- into the wheel. The foot seal -6- is always fitted with new valves!
2. Place O-ring -4- carefully on to the valve from the outside. Mount disc -3- in the correct position -arrow-. The O-ring then lies in the disc
depression.
3. Install the fastening nut -2- with the shaft facing towards the valve foot. Tighten the fastening nut -2- with a torque wrench to 3.5 (2.5 ft. lbs.) ± 0.5
Nm (0.5 ft. lbs.). When tightening, counter with a screwdriver on the slot of the valve foot.