911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Oil Pump: Service and Repair
Removing and Installing Oil Container For Exhaust Turbocharger - Engine Installed
Removing And Installing Oil Container For Exhaust Turbocharger - Engine Installed
Removing oil container for exhaust turbocharger
WARNING:
-
Danger of scalding from draining oil.
-
Danger of burns: Parts of the exhaust system can be extremely hot.
-
Do not begin work until the exhaust system has cooled down or wear suitable protective gloves.
WARNING: Danger of fire: The heat shield should not be bent or deformed. Bent or deformed heat shields must be replaced.
Requirement: Remove rear spoiler.
1. Remove heat shield.
2. Unscrew the oil drain plug -arrow- of the oil container and collect any emerging oil.
3. Unscrew the M6 screw on the heat shield -arrow-.
4. Undo both union nuts of the oil lines -arrows- a/f 17 and pull the lines out of the oil container by removing the M6 screw -arrow- from the oil line
holder.
Oil line holder