911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
Unlocking tool to unlock the old contacts in the plug connection.
Unlock the old contacts of the micro-switch wires with the unlocking tool and remove.
Installing microswitch
1. Install new contacts of the microswitch wires
Reinstall the new contacts of the microswitch wires in the same position and close the secondary locking of the plug connection with a small
screwdriver again.
2. Install and fasten upper microswitch -1- with bracket
Turn threaded spindle until the fastening screws -2- can be screwed down with an angle screwdriver (Torx T10).
3. Fasten the line routing Fasten the line under the upper microswitch with a tie wrap.
Position line in the retaining clip.
4. Install lower microswitch
Install lower microswitch and fasten the fastening points (plastic) with the retaining clips or carefully heat them with a soldering iron until the
material starts to flow. The microswitch must be seated firmly in the fastening points after the material cools.
5. Fasten the line routing
Fasten the cable under the lower microswitch with a tie wrap.
6. Install rear side section flap.
Tools and materials