porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 292 > < Procedures|Page 290
Page 4
background image

Pin assignment of adapter lead -E-

Installation

Caution: 
The airbag will not function if the spiral spring in the airbag contact unit is damaged. Observe mounting specifications.
^

Avoid uncontrolled twisting of steering wheel in the wheel position (by turning the steering wheel when the universal joint is being
removed on the steering shaft). This means that if the steering wheel is turned to fit the steering angle sensor, the same steering wheel
position, and thereby the position of the spiral spring in the airbag contact unit, must be re-established before fitting the universal joint.

^

The front wheels, steering wheel and airbag contact unit must be positioned correctly in relation to one another before the universal joint
is fitted on the upper steering shaft, i.e. they must be in the same positions that they were in before the removal (the steering wheel and
spiral spring are positioned centrally and the wheels are in a straight-ahead position).

Information: 
^

The steering angle sensor and its hub adapter must engage audibly.

^

Use a new fastening screw on the universal joint. Observe the tightening torque of the screw.

^

When replacing the steering angle sensor in pre-2003 vehicles, ensure that the components in the surrounding areas are correctly assigned (this is
determined by the steering angle sensor version that is used).

^

The steering angle sensor has no defined zero position when new. The position for "straight ahead" direction of travel must be programmed. This
is done by calibrating with the Porsche System Tester, when the wheels are in a straight-ahead position, on the measuring station.

1. Secure the steering angle sensor to the steering column (steering shaft) in 2 stages. Stage 1: Secure (engage) adapter -1- to the steering shaft. Stage

2: Fit steering angle sensor to adapter -1- detailed instructions on how to do this will follow).

1 - Hub adapter
2 - Driver for steering angle sensor
3 - Internal locking tab (for securing to the upper steering shaft)

Procedures|Page 292 > < Procedures|Page 290