911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
4.4
Carefully press the bushing into the gearshift bracket using a vice --> Figure 8 -B-. When doing this, ensure that the gearshift lever pin is
positioned in the bushing and the base of the bushing in flush with the --> Figure 8 -D- gearshift bracket.
4.5
Press the second bushing into the gearshift bracket in the same way --> Figure 8 -B-.
4.6
Check that the new gearshift lever moves smoothly in the bushing.
5.
Concluding work:
5.1
Install gearshift bracket.
5.1.1 Insert the gearshift bracket and tighten nuts --> Figure 9 -A-.
Tightening torque: 10 Nm (7.5 lb-ft.)
5.1.2 Grease and attach selector cable --> Figure 10 -A-, then install protective cap --> Figure 10 -B-.
5.1.3 Grease and install shift cable --> Figure 10 -C-. To do this, insert a large screwdriver through the side opening in the gearshift bracket and
press end of shift cable on to the ball head.
5.1.4 Insert support --> Figure 10 -D- in gearshift bracket and secure with locking clips --> Figure 10 -E-.
5.2
Check shifting in all gears.
5.3
Install center console --> POSES, Workshop Manual Serv. No. 6817. "Installing center console".
5.4
Test drive.
Working Time
References: --> POSES, Workshop Manual, Serv. No. 6817 - "Removing and installing center console"
Disclaimer