928 GTS V8-5397cc 5.4L DOHC (1994)
Power Steering Pump: Service and Repair
1.
Disconnect battery ground cable.
2.
Disconnect intake hose at left side of air cleaner.
3.
Remove fluid from power steering pump reservoir.
4.
Raise and support vehicle.
5.
Remove splash shield.
6.
Slightly loosen attaching bolts at front of power steering pump.
7.
Remove attaching bolt at rear of power steering pump.
8.
Remove power steering drive belt.
9.
Remove left upper section of timing belt cover.
10.
Disconnect pressure hose at power steering pump.
11.
Loosen clamp, then disconnect suction hose at power steering pump.
12.
Remove attaching bolts at front of power steering pump, then remove pump and bracket as an assembly.
13.
Reverse procedure to install, noting the following:
a. Position pump by tightening front attaching bolts, then insert but do not tighten rear attaching bolt.
b. When installing replacement pressure hose, ensure protective ring rests on spring strut mount.
c. When installing original pressure hose fitted with asbestos sleeve, leave not more than 25 mm between inner wheelwell and hose.
d. Torque suction hose attaching bolt to 43 ft. lbs.
e. Adjust power steering and alternator drive belts and bleed steering system.
