928 S4 V8-4957cc 5.0L (1987)
5. Turn engine in direction of rotation to TDC (cyl. 1). Marks on camshaft and flange bearings must be aligned in this position.
RH Camshaft
LH Camshaft
6. Turn engine two more turns until TDC mark is reached again and then continue turning while checking toothed belt for wear and damage.
7. Prepare Special Tool 9201 for checking. Pull out lock pin on special tool and move testing pin opposite the lock pin to starting position. Place
drag needle on gauge needle.
8. Slide special tool on released belt section of toothed belt (sliding shoe on smooth surface, roller must fit in tooth gap).
