944 L4-2681cc 2.7L (1989)
Figure F
3.
Concern: Water leak from fuel filler neck area (Figure F).
Correction:
Seal the following areas indicated by arrows with RTV sealer.
-
Filler neck grommet (inner and outer diameter)
-
Filler door mounting screws (qty. 2)
-
Filler door rivet (qty. 1)
-
Filler door rubber stop screws (qty. 2)
-
Rubber flap screws (qty. 2)
-
6 mm mounting bolts (qty. 2)
Apply a filler bead of silicone to the inside edge of the filler flap opening. Smooth the bead with a wet finger and wipe away any excess sealer. From
inside the trunk, check the drain hose for the filler neck area for restrictions and proper routing.
Figure H
Figure I
4.
Concern: Water enters from mounting bolts for rear quarter applique panels.
Correction:
From inside the trunk, seal the five main mounting bolts of the side appliques using sealing patches or flexible sealing putty (Figure
H). Also seal the two upper corner mounting bolts (arrows, Figure I) from inside the trunk. Seal all rear applique mounting bolts
using sealing patches or flexible sealing putty.
