944 L4-2681cc 2.7L (1989)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
REMOVAL
1.
Disconnect battery ground.
2.
Remove air cleaner upper cover and filter.
3.
Loosen clamps and remove both air pipes.
4.
Disconnect fuel supply and return lines.
5.
Disconnect vacuum line from fuel pressure regulator.
6.
Disconnect cable from cruise control motor.
7.
Remove spark plug cable from plug ends.
8.
Unscrew distributor cap.
9.
Remove fuel rail attaching screws from valve cover.
10.
Lift off fuel rail with injectors, injector wiring and ignition spark plug cables. Set aside.
11.
Disconnect throttle cable from throttle body.
12.
Remove all vacuum lines from intake manifold.
13.
Remove intake manifold and throttle body.
14.
Disconnect idle speed control electrical connector.
15.
Remove allen head screw and lift out idle speed control with bracket.
16.
Remove rubber air line and remove idle speed control from bracket.
INSTALLATION
NOTE: Installation is the reverse of removal, with the following notations.
1.
Note arrow marking on unit. Arrow should point to intake manifold.
2.
Position all hose clamps and vacuum hoses correctly.
3.
Use new intake manifold seals.
4.
Torque banjo bolt to 7 ft.lb (10 Nm).
