968 Cabriolet L4-2990cc 3.0L DOHC (1993)
3.
In the area shown in Figure 2, place a 1 cm long spot of adhesive (PNA 915 400 40) and reinstall the rubber strip on the rocker panel cover.
4.
Place additional adhesive in the area shown in Figure 3 and reinstall the rocker cover to the vehicle with all necessary hardware. Make sure any
excess adhesive is cleaned from the body and/or rocker cover immediately.
It may be necessary to lightly clamp the rocker cover until the adhesive sets up.
Note:
Adhesive is very difficult to remove once it has cured, so be sure to remove any excess immediately.
5.
To remove a rocker panel cover which has been installed with adhesive, use a heat gun in the glued area to soften the bond.
Parts Information:
Part Number
Description
PNA 915 400 40
Adhesive
944 559 173 00
Left rocker cover
944 559 174 00
Right rocker cover
944 559 273 00 01C
Left rubber trim
944 559 274 00 01C
Right rubber trim
Warranty Information (if applicable):
Damage Code:
6631 15 0002
Labor Operation: 6631 1900
R & R 1 rocker
100 TU
panel cover