Removing Engine Mount in a 1993 968 Cabriolet
Engine Mount: Service and Repair
Installation
1. Insert mount so that twist is positioned on stop at rear on righthand side and press top of mount into front axle crossmember.
2. Push correctly positioned driveshaft universal joint onto steering gear pinion.
3. Install front axle crossmember, raise crossmember with suitable lifting device to facilitate insertion of bolts, center crossmember and torque
mounting bolts to 84 Nm (62 ft lbs).
4. Install but do not tighten mount attaching nuts and bolts.
5. Remove tool VW10-222, then connect air flow sensor electrical connector and the air cleaner vent hose.
6. Using new self locking nuts, torque to 30 Nm (22 ft lbs) in order; hydraulic engine mount to front axle crossmember, hydraulic engine mount to
engine brackets, universal joint to steering gear.
7. On models equipped with power steering, secure return line and, if applicable, the brake pad wear indicator wire on side member.
8. Install right engine mount shield, stabilizer and splash guard, torquing stabilizer to body and control arms attaching bolts to 23 Nm (17 ft lbs).
