Boxster (986) F6-2.5L (1998)
Hall Effect Sensor: Technical Service Bulletins
Intake Camshaft/Hall Sensor - Delivered WIthout Rotor
911 (996)
10/98 1505
Binder - 1, Engine
Camshaft/Hall Sensor Rotor Installing
Date: 12-17-98
Vehicle Type:
911 Carrera (996)
Model Year:
As of 1999 (X)
Concern:
Change of spare parts - intake camshaft.
Information:
Effective immediately, intake camshafts supplied as spare parts are delivered without the rotor (sensor tab) for the hall sender. A new rotor
(996.105.129.52) must be fitted before a new intake camshaft is installed.
Parts Information:
996.105.221.55 Intake camshaft for cylinder bank 1 - 3
996.105.216.55 Intake camshaft for cylinder bank 4 - 6
996.105.129.52 Rotor (sensor tab) for cylinder banks 1 - 3 and 4 - 6
Work Procedure:
Fitting of rotor on the intake camshaft for cylinder banks 1 - 3 or 4 - 6.
-
Clean the mounting area of the intake camshaft and rotor thoroughly (must be free from grease - e.g. with "Loctite Cleaner"). Coat the seating surface
of the rotor with "Loctite 270".
-
Affix the new rotor in the correct position by hand.
-
On a workshop press, use the pressure piece - special tool 9628 - to press the rotor onto the seat of the inlet camshaft. Use pressure plate VW 402 as
the camshaft support surface on the workshop press.
Literature:
Boxster Technical Manual, Group 2, page 28-2, section 28 44 19 - Removing and installing rotor for hall sender.
Warranty Info.:
Labor Operation
Time Units
Description
28 44 23 50
20 TU
Installing 1 rotor for hall sender
28 44 24 50
30 TU
Installing 2 rotors for hall sender