porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5304 > < Initial Inspection and Diagnostic Overview|Page 5302
Page 60
background image

Measurement tool set No. 9684

Optical waveguide test line No. 9712

PCM2 Gateway - Introduction

Gateway - Introduction

The manual contains the diagnosis for the following system:
PCM2 gateway

General Instructions/Safety Instructions

The following points must be observed during vehicle diagnosis:

-

After the battery is connected, volatile memories must be reprogrammed. In the case of radio coding and tuning, the customer must be informed of
decoding and the deleted tuner memory.

-

Deactivate the 'automatic traffic announcement' before beginning the diagnosis on the PCM2. If this is not done, the system will crash.

-

When working on the optical waveguides, please observe the instructions in assembly;  refer Optical waveguide - MOST bus.

-

After troubleshooting or repairs, erase the fault memory with the Porsche System Tester II No. 9588 and carry out a test drive.

-

Nach der Probefahrt erneut Fehlerspeicher mit Porsche System Tester II No. 9588 auslesen.

DANGER:

Danger of injury through triggering of driver's airbag

-

Never hang the Porsche System Tester II No. 9588 over the steering wheel.

Initial Inspection and Diagnostic Overview|Page 5304 > < Initial Inspection and Diagnostic Overview|Page 5302