Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-897008.png)
Grease pin for boost spring (arrow) with mating bearing on the boost spring push rod, the boos spring bearing (arrows) and the bearing pins on the
boost spring with Optimal, Optitemp LG 2, part No. 000.043.203.37.
First remove old grease with solvent naphtha.
3.2 Boxster from current Mod. '99
Identification/distinction:
Push rod closed / boost spring components coated.
The date of introduction for this boost spring is contained in the Parts Catalogue.
Engage the hexagon-socket bolts of the boost spring into the hexagon on the clutch pedal (arrow).
Important: Do not lubricate since the sliding surfaces of this boost spring version are coated. 'Do not lubricate' applies to all sliding surfaces
(boost spring pins, boost spring bearing in the bracket, bearing pins on the boost spring, and the boost spring in the boost spring pot).
Note Silver bracket (986.423.571.00) and boost spring with white marking (986.423.081.08 Mod. '98 / partly Mod. '99 or 986.423.081.11 from
current Mod. '99) must be used only in this combination and installed only in the Boxster.
4. Installation and adjustment specification for boost spring bracket. Install preassembled boost spring bracket with clutch pedal lever. Valid only for
Boxster vehicles before Mod. '98 (bracket cannot be unscrewed or adjusted).
To do this:
