Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-317013.png)
12. Check whether the auxiliary chain tensioners of cylinder bank 1 - 3 and the auxiliary chain tensioner are fitted on the crankcase half.
13. Remove holding-down device 9611.
14. Prepare cylinder-head cover for installation: Clean sealing surface of the cylinder head and cylinder-head cover very carefully. Apply bead of
silicone on the cylinder-head cover. Refer to: Sealing cover for camshaft housing (cylinder-head cover).
Carefully place the cylinder-head cover in the correct position so that the sealing bead is not damaged. Screw two studs or centering pins into the
corners of the cylinder head as centering aids.
Immediately remove silicone material emerging in the area of the camshaft closure cap.
