Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-318015.png)
13. Fit cylinder-head cover. Remove holding-down device 9611. Clean sealing surface of the cylinder head and cylinder-head cover very carefully.
Apply bead of silicone on the cylinder-head cover. Refer to: Sealing cover for camshaft housing (cylinder-head cover).
Carefully place the cylinder-head cover in the correct position so that the sealing bead is not damaged. Screw two studs or centering pins into the
corners of the cylinder head as centering aids. Tightening torque: 13 Nm (10.0 ft. lbs.)
Immediately remove silicone material emerging in the area of the camshaft closure caps.
14. For the subsequent adjustment work on the camshaft, the pulley must be fixed at bore 1 OT (TDC) with the fixing pin (special tool 9595).
15. Fasten blocking device (special tool 9612) on the cylinder head.
Special-tool fitting sequence:
A - Fastening screw with star knob on the cylinder-head lug. Pull back centering piece (B) and sword bolt (C) when tightening.
B - Centering piece in groove of the exhaust camshaft. Pull back sword bolt (C) when tightening.
C - Sword bolt
