Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-1041006.png)
6. Insert steering column cover from below, position and fasten (with Torx screws).
7. Install steering column switch and airbag contact unit with the associated covers. Position the steering column switch before tightening the
fastening screw. To do this, measure with a depth gauge between the end of the steering shaft and the sheetmetal cover of the steering column
switch. Adjusting dimension 55 ± 0.5 mm
The adjusting dimension 55 ± 0.5 mm can also be adjusted or measured with the airbag contact unit fitted.
8. Install the instrument cluster.
Connect the electrical plug connection on the instrument cluster. Push in the instrument cluster at the left and right and clip into place; fasten it
with the Torx screws 5.0 x 22. Press in the hazard warning light switch and fit the plug on the left side. In the version with "telephone with
handsfree unit", plug in the microphone plug instead and engage the microphone in position.
9. Install side nozzle and main light switch.
10. Install steering wheel and airbag unit. Observe the safety regulations for handling airbag units.
11. Connect battery ground cable. Perform function test.
12. If a new transponder (new lock barrel with new key) is used, the new key must be taught.
