Boxster S (986) F6-3.2L (2001)
/f6-3.2l/Page-1118004.png)
If there is not enough space for the wheel hub between the press, appropriate shims will additionally be necessary.
-
Remove retainer plate (lid / four screws) and brake disc cover.
-
Heat wheel bearing housing to approximately 100° C (max. 120° C).
Press out wheel bearing with tubular piece VW 415 A (tool C).
-
Press inner wheel bearing race off the wheel.
To do this, use pressure piece P 297 A (tool A) in combination with the separator (tool B).
Note First pull the inner bearing race several millimeters off the wheel hub so that the separator can be put into place. For this purpose, use a
two-claw puller in combination with a suitable pressure piece (e.g. VW 433).
Installation
-
Before installation, clean the bore in the wheel bearing housing and remove any surface irregularities with a polishing cloth.
-
Heat wheel bearing housing to approximately 100° C (max. 120° C).
Insert new wheel bearing, and then press again slightly using pressure piece 9247/4 (tool D) and tubular piece VW 415 A (tool C).
