porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Keyless Entry - Insufficient Remote Control Range|Page 4628 > < Keyless Entry - Insufficient Remote Control Range|Page 4622
Page 1
background image

Antenna - Keyless Entry: All Technical Service Bulletins
Keyless Entry - Insufficient Remote Control Range

Boxster
7/04 9662

8/31/04

Binder - 9, Electrical

Insufficient Range of Remote Control

Vehicle Type:
Boxster/Boxster S

Model Year:
As of '97 (V)

Concern:

Increasing the range of the remote control by changing the routing of the antenna lead on vehicles with option:

-

Anti-theft protection 315 MHz (I No. 535), this frequency is used for the North American market

-

Anti-theft protection 433 MHz (I No. 534), RDW

Information:

The antenna lead of the remote control was previously incorporated in the wire harness running in the area of the left A-pillar and was muted together
with the wire harness. This caused the antenna lead to have an unfavorable installation position, and, come into contact the wire harness and left A-pillar.

This caused excessive shielding of the antenna toward the outside, reducing the reception strength of the antenna. This lead to the range of the remote
control being reduced. To avoid shielding the antenna and to increase the range of the remote control, the routing of the antenna lead in the area of the
A-pillar has been changed as of the introduction date listed below.

If the customer complains that the range of the remote control continues to be insufficient (e.g., even after the remote control battery has been changed),
the antenna lead should to be rerouted as described in the work procedure in order to increase the reception strength of the antenna, thereby increasing
the range of the remote control.

Introduction:

March 25th, 2004, as of the following VINs:

98 24S 62 0843 Boxster/USA
98 14S 66 0473 Boxster S/USA

March 31st, 2004, as of the following VINs.

98 54U 62 1201 Boxster/USA
98 84U 66 1379 Boxster S/USA

Parts Information

Tools:

Side cutters 
Scissors/knife

Work Procedure:

Change the routing of the antenna lead.

Keyless Entry - Insufficient Remote Control Range|Page 4628 > < Keyless Entry - Insufficient Remote Control Range|Page 4622