Boxster S (987) F6-3.2L (2005)
Remove air guide from front panel.
ATTENTION
The optical waveguide can become damaged due to incorrect installation or if the requirements for handling optical waveguides are not
followed.
--> Observe the requirements for working with optical waveguides --> Workshop Manual '977211V Optical waveguide - MOST bus'
2. Install optical waveguide.
2.1
Remove connection point holder.
2.1.1
ONLY for vehicles with optical waveguide component (navigation unit and/or amplifier) in the luggage compartment:
Disconnect optical waveguide connection point --> Figure 4-B- in the front luggage compartment.
2.1.2
Remove connection point holder --> Figure 4-A- from plenum panel using needle-nose pliers.
2.2
ONLY for vehicles without optical waveguide component in the luggage compartment:
2.2.1
Pull off protection cap --> Figure 5-A- on optical waveguide.
2.2.2
Route optical waveguide from the connection point --> Figure 6-A- along the plenum panel to the CD autochanger installation position -->
Figure 6-B- and secure at this position.
2.3
ONLY for vehicles with optical waveguide component:
Route optical waveguide from optical waveguide connection point --> Figure 6-A- along the plenum panel to the CD autochanger installation
position --> Figure 6-B- and to the amplifier --> Figure 6-C-and secure at this position.
NOTE: If the connection point holder is damaged during removal, use a new connection point holder (see scope of parts). Then push the plug
socket into the new connection point holder.