Boxster S (987) F6-3.2L (2005)
INFORMATION: Always replace the spare parts contained in the "convertible-top covering" scope of parts.
1. All pins and screw joints must be checked for tightness before the convertible-top covering is installed. Refer to Replacing convertible-top frame.
2. Measure the centre between the restraining straps and mark it on the tension bow.
3. Replace the tension strap. Refer to Replacing convertible-top frame.
4. Pull clamping rail -3- into the pull strip -1- of the convertible top covering -2- in direction of arrow.
5. Slide clamping rail -3- through to the inside. Position fastening screw -4- on convertible top covering -2- and screw in by hand by approx. 4 turns.
6. Pull slide -1- into the pull strip -2- of the convertible top covering in direction of arrow.
Installing convertible-top covering
INFORMATION: Make sure that the side of the shaped sheetmetal part does not scratch the styling edge.
1. Lay convertible top covering on the convertible top frame.