Boxster S (987) F6-3.2L (2005)
4. Position cover strips right and left -2- at the cut-outs provided to the padding and clip into the seat frame -3-.
5. Fit cover over the padding without creases.
6. Fit cover piping -1- all around the seat frame with a plastic wedge.
7. Fit cover piping at rear to seat frame with a plastic wedge -arrows-.
Subsequent work
Removing creases in seat cover (leather)
CAUTION: Risk of damage to cover if excessive heat is applied.
-
Creases in cover
-
If creases have formed, only short partial warming with the hot-air gun is permissible.
-
The hot-air temperature must always be Temperature: 50 degrees C.
1. If creases have formed, partially heat the affected areas of the cover with the hot-air gun and smooth out the cover using the special tool.
Scudding knife P 9747
Knurling tool P 9747/1
Bone burnisher P 9747/2
Hot-air gun v.a.g 1416
Subsequent work
Install control part trim panel. Refer to Control part trim panel
Removing and Installing Cover For Front Seat (Folding Sports Bucket Seat)