Boxster S (987) F6-3.2L (2005)
Installing seal for cowl panel frame
1. Place seal for cowl panel frame -1- on the sheetmetal flange on the cowl panel frame.
2. Position seal for cowl panel frame -2- at the left and right and secure with new rivets -1-.
INFORMATION: Make sure that the water drain is not trapped.
3. Press rubber seal for door -2- at the left and right onto the sheetmetal flange and slide in sheetmetal insert - Inset-.
4. Tighten fastening screw -1-. Tightening torque: 6 Nm (4.5 ftlb.)
Subsequent work
1. Install A-pillar trim panel on the left and right. Refer to Removing and installing A-pillar trim panel.
2. Install front roof trim panel. Refer to Removing and installing front roof trim panel.