Boxster S (987) F6-3.2L (2005)
/f6-3.2l/Page-282006.png)
Gear carrier components overview with crankshaft
1. Fasten the special tool retaining device 9607 onto the workbench using two screw clamps.
2. Mark connecting rod 4-6 in the installation position.
3. Remove connecting rods on cylinder side 4-6 one after another. Loosen the two connecting rod bolts on each connecting rod, remove connecting
rod cap. Using a plastic mandrel (possibly an in-house tool) push connecting rod down and out. Immediately after this, screw on loosely to
associated connecting rod cap. Place on a clean surface.
