Boxster S (987) F6-3.2L (2005)
Valve Cover: Service and Repair
Installing
Installing cylinder head cover - engine removed
ATTENTION: Damage due to ingress of dirt
^
Oil bores/oil ducts can become blocked up.
^
When working on the engine, absolute cleanliness is essential.
^
Lay removed engine parts on a clean base and cover them without fail.
^
Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
Note: The coated screws for the bearing surfaces of the camshaft in the cylinder head cover must be replaced when installing.
1. Insert three new seals for the spark-plug recesses.
Only the following sealants may be used to seal the cylinder head cover:
^
"Drei Bond" silicone - type 1209
^
Loctite 5900
2. Prepare cylinder head cover for assembly. Apply a thin bead of sealant on the cylinder head cover (not higher than 1.5 mm). Sealant application
cylinder head cover