Boxster S (987) F6-3.2L (2005)
2. Unclip electric connector -a- and unplug.
Installing halogen bulb
CAUTION: Danger of injury. Danger of material damage if bulbs are used or handled incorrectly.
-
When installed, the headlight has a high voltage.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
To prevent short circuits, the load in question must be switched off when changing bulbs.
-
New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands. To change the bulbs, use a cloth or soft paper.
-
Observe the safety instructions when replacing a bulb in a Bi-Xenon headlight.
-
In certain states, it is compulsory to carry spare light bulbs.
1. Push the electrical connector fully onto the bulb.
2. Engage locking clip.
Installing high beam halogen bulb
CAUTION: Danger of injury. Danger of material damage if bulbs are used or handled incorrectly.
-
When installed, the headlight has a high voltage.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
To prevent short circuits, the load in question must be switched off when changing bulbs.
-
New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands. To change the bulbs, use a cloth or soft paper.
-
Observe the safety instructions when replacing a bulb in a Bi-Xenon headlight.
-
In certain states, it is compulsory to carry spare light bulbs.
1. Push electric connector onto bulb until it clicks into place.