Boxster S (987) F6-3.2L (2005)
Only "Drei Bond" silicone type 1209 should be used as surface seal. After application of surface seal (silicone bead), screw together within five
minutes.
Application of silicone bead
1. At the processing nozzle, cut off the first metering step.
2. Apply a uniform bead approximately 1.5 mm wide to the cleaned sealing surface of the oil pan.
3. Place the oil pan in the correct position carefully, so that the sealing bead is not damaged. Screw two studs or centering pins into the corners of the
crankcase housing halves as centering aids.