Boxster S (987) F6-3.4L (2008)
Brake-piston damping plates no longer used
4. Fit expanding spring. Center the retaining pin in the bore using the M8 auxiliary screw. To do this, push the retaining pin back with the auxiliary
screw and then push the retaining pin through. Remove auxiliary screw and tighten new fastening screw at the retaining pin to 30 Nm (22 ftlb.).
5. Fit warning contact wire on the disc brake pads, expanding spring and brake caliper -Arrows-.
6. Position disc brake pads by actuating the brake several times.
7. Check brake fluid level and correct if necessary. The brake fluid level must be between the MAX-MIN marking.