Boxster S (987) F6-3.4L (2008)
1
- Plug connection for front-end wire harness to main wire harness, right
2
- Fuse box for fan
3
- Connector for front-end control unit
4
- Ground point, left and right
5
- Connector for headlight, left and right
6
- Plug connection between front-end wire harness and front apron wire harness
7
- Plug connection for coolant fan
8
- Connector for control unit for coolant control
9
- Connector for control unit for coolant control
10
- Cable guide for sensor line for airbag, front left and right
11
- Connector for sensor line for airbag, front left and right
12
- Connector for emergency release, front
13
- Connector for outside temperature sensor
14
- Connector for horn, high-pitch
15
- Connector for horn, low-pitch
16
- Connector for servo motor for front lid release
17
- Connector for control unit for garage door opener/HomeLink
18
- Plug connection for microswitch for roof lock, front
19
- Connector for servo motor for lid, front
20
- Plug connection between front-end wire harness and main wire harness, left
21
- Grommet
22
- Tie-wrap
23
- Line holder
24
- Line holder
INFORMATION:
-
If a spare part is requested, a standard wire harness with a connection point (plug connection) is supplied for all models. This wire harness is
installed as of model year 2006.
-
For model year 2005 vehicles, the old plug connection must be removed from the old wire harness and fitted on the new wire harness.
-
Pin assignment according to wiring diagram.
1. Disconnect plug connection between front-end wire harness and main wire harness, right -1-.
1.1. Release plug connection between front-end wire harness and main wire harness, right -arrow a- and disconnect -arrow B-.