Boxster S (987) F6-3.4L (2008)
^
The wheel electronics are removed
^
The self-locking -1- fastening screw is loose
^
The bead seat sealing ring -6- is porous or damaged
^
The valve body -7- is bent
^
The union nut -4- is loose.
The wheel electronics -A- must be replaced if:
^
The housing is visibly deformed
^
The filter surface (square, porous section on back of wheel electronics) is so badly soiled that it can no longer be cleaned by wiping
^
Tire sealant (tire sealing liquid) has been used
^
The service life of the battery has expired
^
There is a fault within the wheel electronics.
After removal of the tire, the wheel electronics -A- can be seen at the valve in the outer rim well base.
1. Release wheel electronics from valve using a Torx socket screwdriver T 20 (if necessary, counter with a suitable assembly pin, e.g. steel pin
[diameter] approx. 1.8 mm in bore at valve foot) and remove it.
2. Then unscrew union nut and remove valve.
Installing wheel electronics
Information: Carry out the tightening procedure to the specified torque for the valve in the rim once only. Remove the assembly pin after fitting the