Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1457016.png)
NOTE:
-
When installing the wire harness, make sure the insulation of the line is not damaged.
-
The line must run over the pneumatic spring for the rear lid.
1. Push the wire harness along the left hinge into the passenger compartment and to the rear spoiler -arrows A-.
2. Pull out the wire harness through the body, roof frame opening -arrow A- downward -arrow B-. If necessary, push lead from the outside.
3. Coat the rubber sleeve with soap suds and pull in -arrow A- , until this is felt to engage in the opening-arrow B-.
