porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Removing and Installing Display and Operator Control Unit (PCM)|Page 7597 > < Removing and Installing Display and Operator Control Unit (PCM)|Page 7595
Page 7
background image

Right/left-hand drive vehicle coding
Right-hand drive
Left-hand drive

14. Select Engine version and code with .F8".

Engine version
Not coded
V6
V8
V8 twin-turbo

15. Select Reversing camera and code with .F8".

Reversing camera
Not installed
Installed

16. Select DVB-T at AV input of TV tuner and code with .F8".

DVB-T at AV input of TV tuner
Not installed
Installed

17. Select AV input of TV tuner selectable and code with .F8".

AV input of TV tuner selectable
Not installed
Installed

18. Further customer-specific settings can be selected and coded in the same way in the other four submenus (Timeouts, Porsche Assistance,

Additional and Freely-selectable codes >> e.g. for Off-Road Navi, Compass, etc., codes can be found in IPAS) of the Coding menu.

19. In the menu PCM MMI, change to MOST actual installed components list; here a version installed in the vehicle (e.g. CD changer) must be

displayed

20. Change to MOST required installed components list; here too the same version (e.g. CD changer) must be displayed - if this is not the case, select

the version and code with .F8".

21. Read out fault memory and erase if required.
22. Use .<<" to quit the menu PCM MMI and change to the menu PCM GW.

In the menu PCM GW:

23. Select Coding and press the .>>".
24. Select Production mode off and code with .F8".

Production mode
Production mode on
Production mode off

25. Select Tuner parameters and code with .F8".

Tuner parameters
Europe
USA
South America
Australia
Asia
(South) Africa
Japan

26. Use .<<" to quit the menu PCM.
27. Read out fault memory and erase if required.
28. PCM is now taught.
29. If the PCM/vehicle equipment does not have a DVD navigation unit, then adjust the time/date using the SET button on the PCM and in the menu

PCM system.

30. For vehicle equipment with DVD navigation unit, switch on the PCM in clear surroundings (to load GPS almanac); as soon as four satellites are

identified the almanac will reload. The time is updated again when there is a plausible GPS reception (four satellites). The date and time are also

Removing and Installing Display and Operator Control Unit (PCM)|Page 7597 > < Removing and Installing Display and Operator Control Unit (PCM)|Page 7595