Cayenne (9PA) V6-3.2L (2006)
1. Move the gear support Supporting suspension subframe under the center of the suspension subframe and lift it carefully using a suitable base (e.g.
hard rubber support).
2. For vehicles with Offroad Stabilizer system (ORS): Unclip the lines from the supports at the body so that there is sufficient clearance at the lines
for lowering the suspension subframe.
Note: Front rear-axle bearings: The cardan shaft must not touch the mounting face when lowering the suspension subframe! -Arrow-
3. Loosen the threaded joint at the bearing and carefully lower the gear support until there is sufficient clearance for using the tool.
ATTENTION:
Danger of injury due to falling tools.
^
Danger of crushing and deformation
^
Always use industrial footwear, goggles and protective gloves.
4. Remove washer. Attach separating device -3- between suspension subframe bearing and washer. Insert internal puller -2- into the suspension
subframe bearing. Attach counter support -1- and pull off the washer. Important: Please note that the washer is pressed with the bearing. The
washer becomes loose suddenly!