Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1615003.png)
2. Move the gear support under the engine transverse bar and lift it slightly using a suitable base (e.g. hard rubber support). (The gear support is not
needed for the rear front-axle bearings).
3. Engage the spindle at the eyelet on the engine transverse bar at the side where you want to replace the bearing. Guide the spindle through the lower
trailing arm and tighten the spindle slightly so that the spindle is slightly tensioned.
4. Loosen the suspension subframe bearing on both sides, carefully lower the gear support (loosen the spindle carefully at the same time) until you
get the clearance needed for using the press-out tool.
5. Press out suspension subframe bearing.
Note: Hold the hydraulic cylinder VAS 6178 tightly while pressing it out.
